Arctic Chat : Arctic Cat Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
61 Posts
Discussion Starter · #1 ·
It was real easy,first install new carb boots on your tripple,make shure that one of them don't seal properly,cylinder will lean out and burn hole in piston,then you can remove cylinder,piston and reed,then bolt steel plates over openings,now you have a 530cc twin slaphappy Any of you mountain men have a good used cylinder and piston ya wana sell.Cat-Girl :chug:
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top