Arctic Chat : Arctic Cat Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
I have a 1995 zr700 that I smacked up but the motor only has 2800 miles on it and has a lot of work done to it. So I was wondering if it is possible to put that motor in a zr900 chassis??
 

·
Registered
Joined
·
476 Posts
welcome call bigblocker! Sorry that I don't have an answer to your question, but hopefully someone will chime in and help out!

Ridegreen:
 

·
Administrator
Joined
·
7,990 Posts
Anythings possible, I would think some of the 2000 ZR 700 motor mounts would work seeing it's the same chassis. I'm guessing that a 2000 motor and a 95 have the same bolt holes in the engine block. Even if you have to make a bracket or mount, just make sure you have the center to center and the offset correct.
I dont think it would be tough of a job at all. Getting those 95 pipes to work might be a little tougher than you think, or at least to use the same exit hole for the muffler. good luck
 
1 - 3 of 3 Posts
Top