Arctic Chat : Arctic Cat Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
32 Posts
Discussion Starter · #1 ·
I cleaned the carbs on this sled, put everything back and now the throttle "bogs". It also idles at about 1000 which is a little low. I am hoping if someone can tell me if I did something wrong. It doesn't seem to matter if you squeeze the throttle or hammer it, it is real sluggish. I did'nt mess with any of the screw adjustments when i disassembled the carbs either. We do not have any snow so I can't even run it except for on a stand. The sled is a 2004 with only 275 miles so I don't think it has anything to do with bushings in the throttle.
 

·
Registered
Joined
·
603 Posts
Check your manual for a carb & choke set up and sync procedure. I have taken carbs off to clean them, reinstall without moving the idle/air screws and the choke plungers and carb slides are a touch out of adjustment.
 

·
Registered
Joined
·
32 Posts
Discussion Starter · #3 ·
Thanks. I will check it out, but I also have one other question from reading the service manual. Which is the pto side and which is the mag side? How do you tell?
 
1 - 7 of 7 Posts
Top