Arctic Cat Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
335 Posts
Discussion Starter #1
I would like to buy a rispsaw 1.25, but not sure if it will fit. If it does, will studs also clear? How long of studs should I get.

Thanks
 

·
Registered
Joined
·
659 Posts
I'am not sure about the 99 chassis, but on the 97 a 1.25 ripsaw is very close and you can't run studs not even down the center. If you want to run studs I would say an aggressive 1" lug

just my 2 cents.
 

·
Premium Member
Joined
·
8,602 Posts
Yes you can run the 1.25" on a 99 chassis, I didn't run studs on mine so I'm not sure there, but I would think you would be able to.
 

·
Registered
Joined
·
500 Posts
i run a 1" 3/8 on my 97 no problems
 

·
Registered
Joined
·
186 Posts
I run a 1.25 ripsaw with 1.40 studs down the center belt with no problems on my 97. I am not sure if they did it on the 99 but my model had extra mount holes for bigger lug tracks.
 

·
Registered
Joined
·
389 Posts
It is very close but it will work. Studs make it even closer but, guys are running them. I looked at putting the exact same track on my 00 T-Cat but opted for the 1" Hacksaw instead. When I talked to Tracks USA he said they sell the 1 1/4" tracks to the T-Cat guys all the time. I just didn't want the studs that close to the front cooler. Peace, beeler
 
1 - 9 of 9 Posts
Top