Arctic Chat : Arctic Cat Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
168 Posts
Discussion Starter · #1 ·
Std 06 700 Xfire
My wife bumped a tree last night and bent the saddle of the left ski.
So I put on a replacement ski I had, and readjust tie rods to set
ski alingment.
Now I do not get full range of turn.
I noticed that there was a C clip on top of the left spindle do I pull the
clip loosen the assembly and rotate that or is that shaft splined?????
Does anyone have the Exploded view of that Assembly.
Help
 

·
Registered
Joined
·
57 Posts
Sounds like you might have bent something that is a little less obvious. Yes, there is splines where you are refering to but if you notice the jam bolt, the spindle is milled to accepted that bolt so reindexing it can be difficult. In my past experiences if reindexing is needed, there was something else F'ed up.
 

·
Registered
Joined
·
168 Posts
Discussion Starter · #3 ·
Great..... Thanks!!!!
Thats going to cost her a set of Powder Pro's Eh.
Anybody got a gently used set??
 
1 - 3 of 3 Posts
Top