Arctic Cat Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
34 Posts
Discussion Starter #1
Trying to put a water temp gauge in a 2002 zr600 cce. Got my hot and ground off of the fuel pump and third wire to the sending unit, fired up the sled and let it warm up, gauge doesn't seem to work. Took sender out and put in a pan of hot water while still hooked up, still no signal. Seems like this thing isn't working or am I missing something. All ideas will be greatly appreciated.
 

·
Registered
Joined
·
212 Posts
I bet it is an AC/DC current issue. Not not the band. Sleds are wired different than like a car. Not sure. Someone with more knowledge will post up.
 

·
Registered
Joined
·
34 Posts
Discussion Starter #3
Hey, never mind. I figured it out finally. Found a spot on the sending wire that was bare and grounding out on the frame. Still had to tie into the brown ground wire on the sled to get it to register along with the ground from the fuel pump. All is good now!!!
 
1 - 3 of 3 Posts
Top