Arctic Chat : Arctic Cat Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
312 Posts
Discussion Starter · #1 ·
Hi guys . I've got a question , I own a 2012 1000 TRV when I was doing minor "spring" maintenance I looked at the joints that just ride on ny-bushings , my ? is , what does everybody think of installing a zerk fitting so I can grease 'em?? If it would be OK I was thinking good quality grease to be used.
 

·
Premium Member
Joined
·
1,061 Posts
I grease all my bushings. I use Lucas Red and Tacky for my bushings. My lower ones have grease zerks from the factory, I added zerks to the upper ones. I usually take the a-arms off completely and grease them, and check the bushings.
 

·
Registered
Joined
·
312 Posts
Discussion Starter · #4 ·
I think I will.............a little grease shouldn't hurt...............I have a few tubes of extreme temp. high lithium content I use for my sleds.
 
1 - 5 of 5 Posts
Top