Arctic Chat : Arctic Cat Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
so I was checking my tie rods and I grabbed the outer tie rod and was moving it forward and backward on the ball joint and noticed going forward toward the front of the machine it kind of hits a bump or a stop but goes over it is this normal? its not hard to get over the "bump" just can feel a little resistance. any help much appreciated
 

·
Registered
Joined
·
340 Posts
Sounds like a tight spot in either a ball joint or tie rod end or the start of an axle starting to get worn out. Jack the front end up and disconnect the tie rod at the wheels and turn wheels by hand, this should help locate the problem.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top