Arctic Chat : Arctic Cat Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter · #1 ·
I want to upgrade the bars on my '06 F6 (mine stock ones are a little tweaked)... I'm happy with the stock riser - any suggestions on good aluminum after market bars? And would they fit the stock risers - or different clamps required? And... where to get them?

Is it possible to re-use stock grips? ie. Use compressed air to remove?

Thanks for any info - pics would be great too... :thumbsup:
 

·
Registered
Joined
·
703 Posts
Only problem with aluminum bars is they tend to conduct heat so well, that warmers dont do a real good job... from what i have heard. The stock bar diameter is 7/8" so select a bar with that diameter to reuse the clamp and riser you have.

As far reusing the warmers, you can but its tricky. The element for the heater can be saved but you have to slice the grip (shallow), peel back the rubber grip and remove the element from the bar. Have someone clear this up for you, or do a search to verify the removing instructions. I havent actually done it myself
 

·
Registered
Joined
·
40 Posts
Discussion Starter · #3 ·
Thanks for the info - I hadn't considered compromising the warmers performance... good point.
 
1 - 3 of 3 Posts
Top