Arctic Chat : Arctic Cat Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
14 Posts
Discussion Starter · #1 ·
1999 ZL 500 EFI

I removed my skid today to replace the wear strips and the rear shock that broke in half. The problem im having is that after i get the 2 front bolts in, the rear does not line up. I think my problem is that when I took out the shock I didn't mark which hole the top mount connected to. Does any one know which hole should the upper shock mount go into.... the single top hole or which one of the 3 lower holes.
Thankx Everyone.
 

·
Registered
Joined
·
309 Posts
you should be able to look at hole and see were the bolt was . if you are not using a rachet strap to compress the suspension the holes will not line up . you can also release your springs from the rail and compress the suspension to line them up . hope this helps
 
1 - 5 of 5 Posts
Top