Arctic Chat : Arctic Cat Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
1994 XLT 580 EFI -I was out sledding and unfortunetly the left ski was spun around clockwise to the rear. Once I turned it back forward, the top of the spindel wasn't lining up with the ball joint that is attached to the tie rod. Now the steering is messed up(left ski points inward while right is forward). How does that get replaced or straightened?
 

·
Registered
Joined
·
320 Posts
isnt your ski post splinned?? Couldnt you just pop off the spindel, rotate the ski to were it looks straight then put spindel back on and use your tie rod for fine tunning toe-in/out? Sounds like you put it back together with the ski turned inward...

Sorry dont remember the Xtra Lettuce and Tomato that much...but if you took a pic i may be able to help a little better
 

·
Registered
Joined
·
320 Posts
if you do take a pic, take one of both sides so we can compare the two
 

·
Registered
Joined
·
4,095 Posts
I believe the spindles are welded on those sleds, but give it a good look. The toe in / toe out is adjusted with the tie rods.


 
1 - 4 of 4 Posts
Top