Arctic Chat : Arctic Cat Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
149 Posts
Discussion Starter · #1 ·
i just rebuilt top end, rs blew piston. everything back together good, new compression is fine, cleaned power valves, reinstalled. sled wont go over 6400 RPM's. checked movement of serve it reacts at around 6700 rpm's. with out a load. the one thing i noticed is that when i initially start sled there isnt a high idle it starts and runs at 1700 at start up. before it always had a high idle cold then ran down to idle. is there something that i didnt do after rebuild? safe mode?

thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top