Arctic Chat : Arctic Cat Forum banner

replacing cv boot 2003 400 4x4 ATV

734 views 2 replies 3 participants last post by  Gmanf61 
#1 ·
Having an issue popping out the CV joint so I can replace both boots. I understand there is a c clip holding it in and a good pop will release it. No such luck.Any suggestions ?
 
#2 ·
Yep, it’s a small C clip holding it in. Try taking opposite side axle out. You can get a long pointed punch in there and hammer it out while someone is pulling on it. There’s a small dip in inner cup where punch will sit.
 
#3 ·
I use a air chisel and it's very easy. Put the chisel against the axle lip and just bump the trigger and they pop rite out.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top