Arctic Cat Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Have not been here in a while, I need a little expert advice to make sure I'm doing this right. I am working on my 700 prowler XTX EFI 4x4 front right (passenger side) half shaft axle. It feels like the push in ball to release clip type but it wont come out, what type would factory original be. It is the original shaft and has been there for eleven years. I Just repaired and reinstalled my actuator 4x4 and diff lock and don't want to bust something. info and advice needed much thanks for any help.
 

·
Administrator
Joined
·
36,552 Posts
Download a free service manual at countrycat.com.
Pretty sure 2009 was the cutoff. You have the old style push in and pull out sharply.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #3
[QUOTE="doorfx, post: 3694154, member: 118511" Thanks, will do.
Download a free service manual at countrycat.com.
Pretty sure 2009 was the cutoff. You have the old style push in and pull out sharply.
[/QUOTE]
 

·
Registered
Joined
·
4 Posts
Discussion Starter #5
Thanks for all the help. Pull sharply works great with a slide hammer rented from auto parts suppler.
 
1 - 5 of 5 Posts
Top