Arctic Chat : Arctic Cat Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
670 Posts
The power valves could be carboned up and stuck or not moving enough or the cables are out of adjustment (Was the recall on the APV's done?). I also had this condition when my voltage regulator fried because of a bad bearing on the driveshaft (it's part of the speedo sensor). It wiped out all my light bulbs and my CDI box, and at that point the engine still ran, but the servo would cycle backwards (yes- backwards) 3 times. Probably just stuck though....

FYI, it is easier to read a post when the caps lock is off.... :beer_cheers:

Do you have a manual? If not I could try to include the APV section.....
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top