Arctic Cat Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
How on earth do I replace the rear output shaft seal (I think that is the correct term)?? On a 07 700 EFI??

I have the FSM but there is nothing in there that describes this procedure..

I need to remove the drive shaft (The FSM says you need to unbolt the engine/trans to do this????)..

So basically.

I need
1. Proper procedure to remove drive shaft.
2. Proper procedure to replace seal at the back of the engine/trans assembly where the driveshaft bolts to..

Help plz, I've tried searching here and got lots of info on HIDs, and such (!?!), and tried google, and all I got back was Kawi guys saying how easy of a job it is, but in looking at the FSM it appears to be mighty tough!!

Help please!

Thanks!
 

·
Premium Member
Joined
·
8,170 Posts
Are we talking the seal on the motor....or the rear diff?
 

·
Premium Member
Joined
·
1,673 Posts
<div class='quotetop'>QUOTE (BoostedDodge @ Nov 21 2009, 02:48 AM) <{POST_SNAPBACK}></div>
1. Proper procedure to remove drive shaft.
2. Proper procedure to replace seal at the back of the engine/trans assembly where the driveshaft bolts to..[/b]
looks like on the motor.
 

·
Registered
Joined
·
5 Posts
Discussion Starter #4
Yeah the seal on the motor itself.. Looks like out is seeping out from behind the flange that the drive shaft bolts to.
 
1 - 4 of 4 Posts
Top