Arctic Cat Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
No power to ignition???
2008 Arctic Cat 700 H1 EFI
So my bike ran great on Saturday with no gliches. Sunday I went to move it to give it a bath but no go. I turned the key and nothing, no display on the screen. At first I thought the battery was dead but it was ok. Fuses are ok but no power going to the ignition fuse. I have power to the ignition switch. I ran a few more checks but nothing came up. I suspect another rubbed through wire but before I start removing all the skins I'll give a shout out for some more ideas or tests that I should check prior.
Help!!!
 

·
Administrator
Joined
·
35,591 Posts
Bad ground connection , frame , engine, battery. Have you load tested the battery ?
 

·
Registered
Joined
·
9 Posts
Discussion Starter #3
The battery is new. If I turn the key to the second notch then the headlights will come on. I can jumper across the solenoid and it will crank over.
 

·
Registered
Joined
·
19 Posts
I am having the same issue. When I press the start button my gauge powers up and give me engine codes that all relate to my tilt sensor.


Fuel off
C0064
P0562
P0231

Did anyone come to a conclusion on the issue. I am currently trying the gauge reset to see if it works.
 
1 - 5 of 5 Posts
Top