[pysco]

just took out my 2004 600 mc out of storage,put gas in it 4or5 pulls and she started up,idles pretty good but when you give it full trottle from dead stop it hisatate's, it then picks up not bad but only hits 40 mph at about 7200 rpm's that's all you can get out of it,take the plugs out and one seems not to be burning good,its not changing color at all the other one is turning a nice tan color.(any ideals whats wrong?)it worked fine when it was put up last spring.did a resistance test on the coil the reading should be between .24ohms and .36ohms the reading i got was .40ohms would this little bit of a differance be causeing me the problem?

 

[Shaneo13]

<div class='quotetop'>QUOTE (pysco @ Feb 4 2007, 03:12 PM) <{POST_SNAPBACK}></div>

just took out my 2004 600 mc out of storage,put gas in it 4or5 pulls and she started up,idles pretty good but when you give it full trottle from dead stop it hisatate's, it then picks up not bad but only hits 40 mph at about 7200 rpm's that's all you can get out of it,take the plugs out and one seems not to be burning good,its not changing color at all the other one is turning a nice tan color.(any ideals whats wrong?)it worked fine when it was put up last spring.did a resistance test on the coil the reading should be between .24ohms and .36ohms the reading i got was .40ohms would this little bit of a differance be causeing me the problem?[/b]

Dirty clutches... They are probably just stuck...

 

[roy1]

Did you put new spark plugs in and try it? Did you clean your APV valves (May have a stuck one)? Troy

 

[pysco]

the clutchs are good,new plugs and the apvs are cleaned.

 

[NumbNuts918]

<div class='quotetop'>QUOTE (pysco @ Feb 5 2007, 04:19 PM) <{POST_SNAPBACK}></div>

the clutchs are good,new plugs and the apvs are cleaned.[/b]

Did you check the servo control for the valves? It could be hanging up.

 

[pysco]

SERVO is working fine.the sled is not burning the fuel to one cylinder.any other ideals i'm starting to panic we only get short winters here.

 

[brudkavich]

Your gas has probably gone bad from sitting. Dump the old **** out and fill it up with new gas and you'll most likely be good to go.

Peace


:beer_cheers:

 

[pysco]

all the gas was drained last spring,all new put in this winter.

 

[Cam]

Try starting with both plugs in but with the plug wire of the bad cylinder on a spare plug and check for a good clean spark