Arctic Cat Forum banner

1 - 10 of 10 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hello everyone, I’m bored so i thought I’d post this incase it may help someone. I few months ago i was having issues with overheating. So i replaced thermostat, temp sensor and that light sensor right above the thermostat. Oh yeah and the rad cap too. Finally when i checked the pump and bled the system i think i had a trapped air pocket and it was all good. But I’m paranoid so i bought a temp gauge on amazon and believe it or not the sensor fits because its for a suzuki and thats the motor. Heres a picture and it comes in red too( wish i knew that before i ordered but oh well)
 

Attachments

·
Administrator
Joined
·
37,166 Posts
Nice! Did you bleed the cooling system with the bleeder screw?
 

·
Registered
Joined
·
8 Posts
Discussion Starter #3
Nope, didnt see that until after i took the housing off. I needed to see if the pump was still spinning anyways.
 

·
Administrator
Joined
·
37,166 Posts
I made the same mistake years ago lol. We will never do that again lol
 

·
Administrator
Joined
·
37,166 Posts
Do you have a service manual?
 

·
Registered
Joined
·
8 Posts
Discussion Starter #10
1 - 10 of 10 Posts
Top