Arctic Chat : Arctic Cat Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter · #1 ·
Hello all,

I have a primary clutch, it's a newer style 6 tower clutch. I want to run it on my wife's 01 Mountaincat 600. Does anyboday know what I should run for weights, and spring? It engages around 3900 rpm with a red spring, I think that's pretty good. It has 49.5 gram weights and it pulls about 8100 rpm. Can I run Comet weights in it? If so the setup for a comet clutch which appears to be almost identicle red spring / A25 weights.
Please let me know your thoughts
 

·
Registered
Joined
·
1,170 Posts
If you have a primary from a f-7 it will NOT fit onto your 600. The taper of the crankshaft is larger on the f-7. If you had one from an f-5 then you would be ok to just swap your stock weights and spring into it and go.

Fast
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top