[Spangler92]

I put brand new fuses as well I am getting 10 volts to key switch not sure what I’m supposed to be getting. 12 volts is what I’m getting at every hot point

 

[doorfx]

Download a free service manual at countrycat.com. The test procedures are in there.
sounds like you found the problem

 

[Spangler92]

So after testing the switch. I do believe it’s the switch guys, so I’m hoping if I did my test right which I followed the service manual and it says to pull the key switch from the battery connector to where you just have Male adapter side of the key switch off. Then with multi meter check your pins. With key turned to on position. The meter being on ohm’s selection shouldn’t read more than 1 ohms if it does replace it. As I am going off of service manual details. I will post a screenshot of test points on switch and what points need to be checked in each position. Thank you to the guys that were giving input on what I should try, when my switch gets here I will let y’all know the outcome.

 

[Spangler92]

 

[doorfx]

FYI.