Arctic Chat : Arctic Cat Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter · #1 ·
My wifes sled is an 2001 Mountaincat 600, the stock 9 tower clutch decided to crap the bed. I have purcheased a 6 tower clutch off an 03 F5. Due to the lighter rotating mass I'm not sure how to set it up. With the stock weights and spring from the 9 tower clutch it engages at 6500 rpm. So I changed the primary spring to a red comet spring, it now engages at around 4600 rpm. Comet calls for a red spring and A25 weights, I'm thinking this may work because comet made these clutches for cat I'm told. When the clutch engages now it seems to engage a little soft. At full throttle the rpm is at 8200rpm. I left the secondary setup the same as stock. Any ideas would be greatly appriciated, Or any ideas of the best setup would be appreciated. The sled runs 99% of it's life around 2400 ft of elevation. One last question, I was tod the 6 tower was a better way to go because of less rotating mass (easier on the crank) Should I put a 9 tower back on it?


THANKS IN ADVANCE YOU GUYS REALLY HELP OUT
 

·
Registered
Joined
·
48 Posts
Discussion Starter · #3 ·
So basically you are telling me to set this 6 tower up, the same way I would set up a 9 tower? This sounds too easy, I figured because of the less rotating mass of the 6 tower the weights and spring would be differrent than a 9 tower.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top