Arctic Chat : Arctic Cat Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
WHAT I AM TRYING TO FIGURE OUT IF I CAN USE A MIKUNI 34MM IN PLACE OF MY MIKUNI VM 34MM. I KNOW THE VM HAS A THROTAL STOP SCREW ON IT, DONT KNOW IF THAT MAKES A BIG DEAL OR NOT. THANKS
 

·
Premium Member
Joined
·
4,640 Posts
34mm what? Flatslide? VM designates roundslide. Are you asking about another roundslide or what? What sled is it going on?
 

·
Premium Member
Joined
·
4,640 Posts
Ok, then I'm guessing it's an older model and has a long bell 34 on it. Some 34's have short bell. You'll just need one thats the same. The dimensions are the same on all 34 VM with that one exception of bell length. Some are short, some are long. There might be other differences, like which side of the throat the slide locating dowel is on but that really shouldn't matter as long as you have the slide to match.

I'm not really sure what you mean by a throttle stop screw either. Thats typically the idle adjustment as far as I know and they all have that.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top