Arctic Chat : Arctic Cat Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
179 Posts
Discussion Starter · #1 ·
i just got my micrometer to check cylinders,am putting 2 new ones on anyways but want to brush up my skills a little for my other sleds.i bought a used one so no instructions,i know how to read it and set it but are the 3 rods in the pic gauge blocks.there is a 1",2" and 3" so i am assuming they are gauge blocks to set it with.any help would be appreciated
 

Attachments

·
Registered
Joined
·
179 Posts
Discussion Starter · #3 ·
it goes from 0"-1" 1"-2" 2"-3" and 3"-4".the 3" would be to check it from 3-4 and work your way down with the other ones.thanks for the confirmation,i was sure that is what they were for but never hurts to ask
 

·
Registered
Joined
·
267 Posts
Im a tool and die maker and those rods are calibrating after a few jobs or after changing sizes ie.1"-2" use the small rod and make sure it goes to zero if not adjustments are required
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top