Arctic Cat Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
175 Posts
Discussion Starter #1
I WAS JUST READING ANOTHER POST ABOUT STANDS AND BUMPER BENDING I HAVE A ZR AND A PLASTIC BUMPR I JUST BOUGHT 2 STANDS 4 SLED WILL BE LEAVING IT ON IT

I HAVE SOME 5/8 TITANIUM HEX STOCK AND 1\2 ROUND STOCK IN TI. BOTH ABOUT 6 FT LONG

I WAS THINKING HEX STOCK

THOUGHTS ON BUILDING NEW BUMPER I HAVE ACC. TO MACHINEING EQU.AND BENDERS

HAVE ANY OF YOU GUYS BUILT ANY FOR A ZR, MY BUMPER BENDS NOW
 

·
Registered
Joined
·
6,671 Posts
I posted in that other thread too. I was thinking of going with stainless tube but I don't have a bender. So you have plastic now and it bends?
 

·
Registered
Joined
·
326 Posts
I'm currently building mine I am using some sq. Tubing cut at an angle like the original and both sides r going to be joined by a flat strip of metal and then the bent round tubing. I should be done by Xmas if you want some pick just say so.
 

·
Registered
Joined
·
175 Posts
Discussion Starter #4
ANY PICS WOULD BE GREAT, I WOULD LIKE TO SEE A PIC WITH FACTORY BUMPER REMOVED IF ANY ONE HAS ONE

MINE BUMPER BENDS OR TWEEKS A LITTLE EVERYTIME I PROP IT UP TO WARM TRACK
 

·
Registered
Joined
·
889 Posts
I used a Polaris bumper for now, but will be either buying a new Crossfire style one, or fabbing my own out of sheet metal and round stock.

I need to raise the one in this picture higher before I drill and mount.
 

Attachments

1 - 6 of 6 Posts
Top