Arctic Chat : Arctic Cat Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter · #1 ·
I am having trouble tightening the jack shaft bearing support bracket. I can tighten the two bolts that go through the side of the tunnel, but I can't get to the front bolt. Do I have to take the heat exchanger out?? I took my skid plate off and still couldn't get to it. Really need some help. It just keeps loosening up on me and then a have all kinds of vibration. This is on a 98 ZR500 Thanks
 

·
Registered
Joined
·
908 Posts
the bolt is on the inside behind the engine you can get at it. It is a very tight squize. You have to go from the top side also get your self some green loctite so it wont loosen up again.
 
1 - 2 of 2 Posts
Top