Arctic Chat : Arctic Cat Forum banner
1 - 5 of 5 Posts

· Registered
Joined
·
635 Posts
Discussion Starter · #1 ·
Broke off my kill switch button yesterday. Can i just replace the plastic or do i have to replace the whole kill switch for $50? I don't have the part that broke off (lost in the snow) or i could just epoxy it i think.
 

· Registered
Joined
·
471 Posts
If you really dont want to spend the money on a new switch I would just glue a small piece of plastic on the top so u can pull it up :p.
 

· Registered
Joined
·
635 Posts
Discussion Starter · #4 ·
<div class='quotetop'>QUOTE (Bradd @ Jan 21 2007, 10:00 PM) <{POST_SNAPBACK}></div>
Cost me $50.[/b]
yeah that's the part i don't like for a little piece of 1 cent plastic
 

· Registered
Joined
·
1,140 Posts
Not sure on your sled but on my '02 ZR I was able to replace just the plastic knob itself. I had to use needle nose pliers and turn the "stub" 90* and pull it out. New piece cost me less than $2.00.

Hopoe this helps, look up your sled on www.alpha-sports.com and see if it has a seperate know on the switch or if it is all one piece.

Z-Rider
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top