Arctic Chat : Arctic Cat Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
170 Posts
Discussion Starter · #1 ·
I finally got my 02 ZR 800 flat slide carb back together after rebuilding from top to bottom. I had my carbs gone over by a shop and my jets were 410 on the mains. So I had those changed to 440 and set the needles in the center. The sled seems to run great smoother than ever and what little I drove it around the yard all seemed well except the idle. It is not the throttle cable adjustment holding it up nor is it the mechanical idle screw. Any idea's? What are the (2) white adjustment knobs on the bottom of each carb ?

Pilot 50
Main 440
Starter 130
Needle center
Idle mix 2 turns
fuel mix 1.5 turns
 
1 - 1 of 1 Posts
Top