Arctic Chat : Arctic Cat Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
212 Posts
Discussion Starter #1
do u need to loosen it with a big allen socket? or does that big circlip hold it on to the larger drive gear?

can i get the stock carb settings too plz...just the air screw turns and what ever the adjuster with the plastic knobs are....thanks
 

·
Registered
Joined
·
4,416 Posts
Don't remove the circlip. Remove the shaft retainer which has either a bolt holing it on or as it sounds your has, a big allen socket. It is 1/2" allen. I use a coupling nut with a 5/16 inside thread giving it a 1/2" hex.
 

·
Registered
Joined
·
10,301 Posts
Snow800 said one time if you have to, you can use a cut off chisel and slide it into the socket hole. Did this once in a jam and it worked just like the Allen wrench I have at the shop. Thanks snow!
 
1 - 5 of 5 Posts
Top