Arctic Cat Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Premium Member
Joined
·
3,970 Posts
Discussion Starter #1
thanks to quadman15 he told us how to check out engine codes and he sent it to me so i could pin it for him so here it is:

Here is how to pull up the codes, how to
reset all codes, how to reset the Idle speed
control and Throttle position sensor.

READ COMPUTER CODES​

Key off​

Insert Jumper pin in Diagnostic plug​
Key on​

Read codes on the​

pod display​

Key off​

Remove the jumper pin​

RESET COMPUTER CODES​
Key off​

Insert Jumper pin in Diagnostic Plug​
Put in 4 wheel drive​

Depress the Reverse Override Button​
Key On​

Pod will read AC-00​

All codes have been reset​

Key off​

Remove jumper pin​

SET THROTTLE POSITION SENSOR​
Key off​

Insert jumper pin in diagnostic plug​
Key on​

Loosen Throttle Position sensor retaining screw​
Adjust Throttle position sensor until the mark​
on the pod is centered​

Tighten Throttle Position sensor screw​
Key off​

Remove Jumper pin​

SET IDLE SPEED CONTROL​
Key off​

Insert jumper pin in diagnostic plug​
Hold throttle open​

Key on​

Hold throttle open for 10 - 15 seconds​
Key off​

Here are what all the codes mean:

CODE DESCRIPTION​
S C = Stored code A C=Active Code​
AC00​
No fault detected Active only​
12​
Crank position sensor *​
13​
Manifold Absolute Pressure​
14​
Throttle position sensor​
15​
Engine coolant temp sensor​
16​
Speed sensor​
21​
Inlet air temperature Sensor​
23​
Tilt Sensor *​
24​
Ignition coil #1 *​
26​
Ignition coil #2 *​
32​
Fuel injector #1 *​
34​
Fuel injector #2 *​
40​
Idle speed control​
41​
Fuel pump Relay​
60​
Cooling fan relay​
95​
Sensor power​
96​
Incorrect ECU *​
97​
ECU memory power​
98​
UART Comm Link​
99​
Start/Run not possible​
*​
Will initiate 99​


The following message concerns resetting
various codes and clearing all codes
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top