Arctic Cat Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter #1
can the insert in the shaft where the speedo key goes in be replaced? i try to put the speedo key in the shaft down below and its just spinning not sitting in like it should.i tried drilling the rest of the old one out but its hard not to round out the hole.any suggestions?
 

·
Banned
Joined
·
2,108 Posts
Go to a Cat dealer and order this part number 0120-247.
It is the bushing in the end of the shaft that is 2 bucks for a new one.

Another fix is if the key goes in far enough, if not drill it out slightly, Take and spray some carb or brake clean in the enlarged hole.
Blow it out with compressed air and JB weld it in.

If it breaks again, then you will need to replace the bushing in the end.
Mike
 
1 - 2 of 2 Posts
Top