Catmandoo:
I put a set on both our AC bikes, did without them the first year because I couldnt find the right high temp glue because nobody makes it. First off, cut off the original rubber AC grips, clean the handlebar to a smooth finish, apply the heating element which is equipped with a very strong adhesive after you peel off the backing, when the heater is installed on the handlebar, spread clear silicone all over the handle where the grip will go and push the grip on carefully ligning up the Arctic Cat lettering to your liking. reinstall your end caps.
hope this helps
I put a set on both our AC bikes, did without them the first year because I couldnt find the right high temp glue because nobody makes it. First off, cut off the original rubber AC grips, clean the handlebar to a smooth finish, apply the heating element which is equipped with a very strong adhesive after you peel off the backing, when the heater is installed on the handlebar, spread clear silicone all over the handle where the grip will go and push the grip on carefully ligning up the Arctic Cat lettering to your liking. reinstall your end caps.
hope this helps
