Arctic Chat : Arctic Cat Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
169 Posts
Discussion Starter · #1 ·
I have a 2 inch crack on the side of my hood close to the hood latch. How can i fix it so that you can't tell that there was a crack there? I don't want to rig it or anything. I want it done good so it looks nice.



Shawn :sos:
 

·
Premium Member
Joined
·
8,589 Posts
I've use fusor T21 it comes as two part thats in two tubes but when you use the gun it mixes itself, I put it on the inside and cove it with the heat shield if you put it on the outside then you have to sand it prime it and paint it.
 

·
Registered
Joined
·
22 Posts
There is a product called Triple Bond availvable at Hi-performance Engineering (www.hiperf.com) and others.
It has glue, and an excelerator. There is also fiberglass for strength, used on the back side. After the glue dries it can be sanded, and painted.
The glue bottle has an opening that allows you to pure it right into the crack. That holds it, while you work on the back side.
Hope this helps.

Tom
 
1 - 4 of 4 Posts
Top