Arctic Cat Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
139 Posts
Discussion Starter #1
Hey guys, I'm trying to rebuild my secondary clutch on my F7 including new rollers. I have no problem drifting the lock pins out, but how do you get the roller pin out? Is there a special tool, or a common tool that works good to get the angle to push it out? Any help is appreciated!
Thanks,
tim
 

·
Registered
Joined
·
1,009 Posts
if you have the pins out and the helix off i used a allen wrench and pushed them out ,use a little wd 40 it helps, Cat happy
 

·
Registered
Joined
·
139 Posts
Discussion Starter #5
update: I used both suggestions. I found 2 suitable sized allen keys, started with the smaller of the two, then went to the next... after I lightly heated with a propane torch. (Not a good area to be using the oxy actylene) All done.
 
1 - 6 of 6 Posts
Top