Arctic Cat Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
When the sled is started, the guage has a reading. However, after the initial reading, the guage shows nothing (i.e., as if there is no gas in the sled). Any suggestions? Thank you.
 

·
Registered
Joined
·
4,198 Posts
Float has gone porous n soaks up fuel which sees it say pretty much to the bottom of the tank / gauge reads empty except when the fuel sloshes n moves it higher.
Way to test, fab up a bent coat hanger to snag the float / start sled and gently raise the float up / gauge should follow.
To replace float, disconnect as required to slide the tank back / pull sender out and replace float and arm.
 
1 - 3 of 3 Posts
Top