Arctic Cat Forum banner

1 - 6 of 6 Posts

·
Vendor
Joined
·
102 Posts
Discussion Starter #1
Below is a picture of a piston removed from an engine we received this week. The good news for the customer is that we will have the engine completely remanufactured in less than 2 weeks so they can get right back to riding. Contact us here at nFLOW for all of your engine/transmission reman needs! You can reach us at 812-402-8282 or visit us on the web at www.nflowmotorsports.com.
 

Attachments

·
Administrator
Joined
·
38,399 Posts
Holy crap !? Never seen one collapse before. Heat ?
 

·
Administrator
Joined
·
20,020 Posts
Holy crap !? Never seen one collapse before. Heat ?
Forged slugs CAN COLLAPSE without breaking as a cast slug would.. Seen this before years ago in an 84 CR500 Honda that was running a Seizco slug..

The picture appears to have grain structure of a Wiseco piston, and if it were a cast slug, it would have shattered into dozens of pieces were it put through whatever this one went through...
 

·
Vendor
Joined
·
102 Posts
Discussion Starter #6
And roughly what is the cost to the customer after all that mayhem?
KTFire, it just depends on the make/model of the engine. We have standard pricing for the most common engines we remanufacture, which can be found at www.nflowmotorsports.com. If a customer needs a complete engine reman on something not in the drop down boxes, we quote them on an individual basis. Let us know if we can ever be of assistance. Thanks.
 
1 - 6 of 6 Posts
Top