Arctic Chat : Arctic Cat Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
107 Posts
Discussion Starter · #1 ·
Just taking things apart on my 04 F7 efi (not that I'm bored waiting for snow), and I've got some questions. Is the driven clutch suppossed to float slightly on the shaft like the zr's? How do you check drive/ driven alignment and offset? Will the alignment/offset tool from the zr's fit the firecats? TIA
 

·
Registered
Joined
·
205 Posts
I think your allowed some float. I know the diamond drives are not allowed float but chaincase are. The bar for a zr is different than the firecat I believe.
 

·
Registered
Joined
·
390 Posts
Ideally you would want to shim it to run exactly where it should, but a little float is ok, as long as it is just a little, maybe 1/8" Peace, beeler.
 

·
Registered
Joined
·
370 Posts
You do want a little play. Just a couple thousanths, not much.
 
1 - 4 of 4 Posts
Top