Arctic Chat : Arctic Cat Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
316 Posts
I dont know about stock windshild but I cut mine and it was already a low one befor I put on my handgaurds and they clear it. I also have a 3inch riser. I had to cut the grip on the break leaver side and slide the break lever high low beam switch and all that over I also had to cut out a small chunk outta the throttle side where the barpad meets flush with the throttle "box". I also had to bend the break cable for clearance and I cannot put on the bar pad. but these are Acerbis gaurds off a skidoo, altho I think that all brackets are the same for acerbis. heres some pics, one without gaurds.
 

Attachments

·
Registered
Joined
·
124 Posts
I too have installed handguards. I added 4" bar risers and am using the standard
windshield. If your going to use the standard windshield (non low), then you would
probably have to raise the bars in order to install handguards.

You'll like the feel and comfort of raised bars anyway whether you're climbing hills
or riding trail.

nutkick :scat:
 

Attachments

1 - 4 of 4 Posts
Top