Arctic Chat : Arctic Cat Forum banner
1 - 1 of 1 Posts

· Registered
31 Posts
Discussion Starter · #1 ·
Was at my dealer yesterday picking up my 1000, and noticed a crossfire 8 that was blowing belts. I looked the clutch over and noticed the primary was way too tight on the belt. There needs to be at least 20 thou clearance between the belt and sheaves. Check your belt side clearance if you are blowing belts.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.