Arctic Chat : Arctic Cat Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
17 Posts
Discussion Starter · #1 ·
Hello everyone I have a 2000 pantera 136 with a zrt 800 power plant in it, it is bone stock except for the pantera 1000 flat slides on it. It has a purple primary spring and yellow secondary spring with roller over it revs out to 8000 rmps if I hammer it then it drops back down to 7000 after it revs out but sometimes it works fine for a but then acts up again I cleaned both clutches and changed tbe bushinds on the primary weights, this helped alittle, ive tried every hole now on the 2ndary clutch but still no luck, if I have a passander on the sled it revs to about 7700 rmps top end and 8300 out of the hole, worn out 2ndary spring maybe im not sure any help is much appreciated!
 

·
Registered
Joined
·
10,307 Posts
Yes, could very well be a sached out spring. Be sure to check the rollers in the spider as this will sometimes alter your top rpms.
 
1 - 2 of 2 Posts
Top