Arctic Chat : Arctic Cat Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
I am trying to pull the clutches off my 2010 400 TRV to replace the oil seals. I have the nuts off but the primary or secondary wont budge.. I be been pulling and pulling... Any ideas?? Suggestions?
Thanks
 

·
Registered
Joined
·
3,774 Posts
There is no good reason they would be stuck and not pull right off the shafts, try heating the shafts some with a propane torch maybe by adding a little heat to the shafts whatever it is that's causing them to stick will loosing up enough to get them off.
 
1 - 2 of 2 Posts
Top