Arctic Chat : Arctic Cat Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
164 Posts
Discussion Starter · #1 ·
Just installed a new Speedwerx clutch kit. I seem to have lost almost 10 mph on top end. Does pull real good after say 60 ft right thru top out. Looked the clutches over and found rubber on the top outside edge of the primary, like the belt is running out of the sheave. Am I correct in assuming that the secondary is not fully opening? And should I go back on the spring 1 hole? Any input is appreciated. Am also emailing Speedwerx on this issue to see what they say. Thanks guys.

BTW sled is an 05 Scat 700 LX
 
1 - 1 of 1 Posts
Top