Arctic Cat Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
134 Posts
Discussion Starter #1
was looking through dennis kirk for a clutch puller, and not sure what to get, i have a nine tower on a 550 cougar motor, do i order the clutch puller for the 9 tower or for the motor? there both different part numbers, also was wondering what alignment tool i'd need to align a 650 wildcat motor in a 550 cougar chassis
thanks
 

·
Registered
Joined
·
21,410 Posts
You need a clutch puller to pull the CLUTCH. Not the motor. Make it's one for the Cat clutch, not for the ARCTICO/Comet clutch. The clutch alignment tool is for Arctic Cat. Center-to-center should be 12.2". Clutch offset whouldn't matter what motor is in it, you are aligning the clutches.
 

·
Registered
Joined
·
134 Posts
Discussion Starter #3
Found the clutch puller, dennis kirk doesnt have an arctic cat alignment tool from what i could see online, any suggestions?
 
1 - 3 of 3 Posts
Top