Arctic Chat : Arctic Cat Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
51 Posts
Discussion Starter · #1 ·
I've read a couple posts about drilling the carb slide hole out with a 1/8" bit to get a little extra throttle response and power, and I've also heard that you could get the same outcome by clipping a few coils from the slide spring. Is this true? and if so, which would be better and more effective?
 

·
Registered
Joined
·
947 Posts
never heard of the spring clip, but would save you about 75 bucks if you mess it up, the carb slide is 80 at browns liesure...
 

·
Registered
Joined
·
322 Posts
Alot of people have done the 1/8 drill-out, it works and is pretty much free. Just be sure to hold it firmly and drill speed high and feed it slow, the material wants to "grab" and get pulled thru.
 

·
Registered
Joined
·
332 Posts
Any pics. of the finished slide drilled out?
 
1 - 4 of 4 Posts
Top