Arctic Chat : Arctic Cat Forum banner
1 - 1 of 1 Posts

3,360 Posts
Discussion Starter · #1 ·
I guess there is a fake error code that MAY show on some boxes if you use the 9 volt battery before completely installing the box, and running it. ALSO if you screw up wires then run it and it pops the error code. so connect them correctly and don't use the 9 volt IMO... But the code if it goes away with a button push and doesn't come back is the false code, and the box is 100% fine. They think its just a sensitivity issue and will be less sensitive on the next programming runs. I have installed a few and only one threw a code then was gone, and never came back so...
Jut an FYI
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.