Arctic Cat Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
my ATV it’s a 2005 Cat 500 when I go to start it after it’s been sitting for a couple days. I have to crank It and stop and Crank it and I do this 10 to 12 time . When it does start it kills and then I started again. So when is idling it Hass to idle for like 15 minutes until it gets good and hot before I can hit the throttle to get a higher RPM out of it. Once it’s good warm then it will let me drive it without killing I’m not sure what the problem may be any answers would be appreciate it thank you. I am not shire what is making this happen

Gary
 

·
Administrator
Joined
·
37,459 Posts
Are you using the primer?
 

·
Administrator
Joined
·
37,459 Posts
It’s on the bottom of the carb, two or three pumps
 

·
Registered
Joined
·
4 Posts
Discussion Starter #5
It has a electronics choke and there is no primer ball on the bottom of the carb
 

·
Administrator
Joined
·
37,459 Posts
It’s a primer lever and yes it is there.
 
1 - 7 of 7 Posts
Top