Arctic Chat : Arctic Cat Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter #1
having some debate on what ring gap to use on a 80 el tigre 6000 that is bored and LA sleeved 10 over. going on wiseco site and using there calculations top ring should be 0.011 and bottom 0.013 but instructions in the piston box conflict these numbers at 0.005 less on each ring..The first set of pistons were a older design and only lasted 50 miles untill the pin let go,these other pistons have detonation and pressure grooves but searching has left more questions than answers on if wiseco pistons are a good choice for this sled with steel sleeves. so any info from engine builders is welcome
 
1 - 1 of 1 Posts
Top