Arctic Chat : Arctic Cat Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter · #1 ·
That inner aluminum cover that needs to come off to get at the primary clutch shaft so i can get it off is giving me a hard time...Have the handfull of torx bolts out on the inside face of the cover as well as the 3 or so that are below the bottom of the cover .cannot see any that i missed . Oil is driping at the bottom a bit . Are they normally a little stubborn to get off? suggestions please Thanks in advance
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top