Arctic Chat : Arctic Cat Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2,625 Posts
Discussion Starter · #1 ·
So the spring retainer bolt snapped off and the spring bound the skid up and reamed the rear hole out to about 5/8 of an inch.
There is a set below I can drop the rear to but none on the front. I was under the impression if you drop the rear you gotta drop the front too. Do I need to make a set up front?
 

·
Registered
Joined
·
25 Posts
If you look inside the tunnel where the front bolts go there are holes in the reinforcement plate below the original holes, you just have to drill them out from inside of the tunnel, I just did this last week. I had to drill out the rear holes also as the front set of holes in the rear didn't line up with the rear skid holes when I had the front of the skid bolted in already.

I can get pics if that will help you.
 
1 - 2 of 2 Posts
Top