Arctic Chat : Arctic Cat Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1
Hi all,

I'm trying to put my skid back in after replacing the rear shock arms....oops! On the rear arm parts diagram, it shows a spacer between the idler wheel and the splined block that gets bolted to the arm and then through the tunnel.

I don't seem to have that spacer. It's number 14 in the diagram. Does anyone have laying around that they can take measurements of? I have parts box that I can dig through, but I don't know what I'm even looking for. I would need the material, OD and thickness. It seems to be 1" ID based on the arm splines.

Thanks for your time.
 

·
Registered
Joined
·
4,416 Posts
it is just a spacer to keep the wheel from walking outboard. ID is a loose fit on the arm, a shade over 1", the OD isn't too critical, about 1-1/4" would be OK. Thickness is to fill the space between the bearing and the splined TSL arm. Measure from the inner bearing race to the outside of the arm and then subtract the thickness of the TSL arm (3/4" if I remember right.)
 
1 - 4 of 4 Posts
Top